Adex Electronics, PCIX32-E+, Revision: E+
Bill Of Materials, Page 1 of 1, Last Update: 3/25/98

Item Qty Reference Part Mfg
1 1 U1 16V8-15, dip20. IX1_7A Lattice
1A 1 U4 16V8-25, dip20, IX2_3 Lattice
2 2 R2,R1 33
3 4 D2,D4,D5,D6 GREEN LED
3A 1 D1 RED BLINKING LED
4 3 C6,C7,C10 +10UF, 16V, SMD
5 13 Z2,Z3,Z4,Z30,C32,Z21,Z29 ,Z21,Z22,Z23,Z24,Z26,Z27 .1UF
6 2 Q2,Q3 TO220AB Siliconix
7 3 R3,R11,R16 8.2K
8 1 U2 ANALOG SWITCH Proprietary
10 1 SW1 SW SPDT
* 11 2 R40,R41 2K
*11A 1 R34 12K
*11B 1 R32 10K
* 12 4 R18,R36,R38,R46 15K
* 13 3 R12,R13,R14 4.7K
14 3 R17,R19,R24 560
* 15 3 C3,CR20,CR23 +.68UF OR +1.0UF
16 1 JP2 JPR3
17 2 C1,C2 +10UF, 20V, SMD
18 3 T1,T2,T5 TVS5, SMG
19 2 T3,T4 TVS12
20 4 R4,R26,R27,R43 240
* 20A 1 R25 220, 1% (2200)
21 3 R28,R37,R39 110 ,5% (110)
21A 1 R15 110 ,1% (1100)
22 1 Q4 SI9400DY or SI9435DY or IR7205 Siliconix or IR
23 1 Q5 SI9955DY or IR7103 Siliconix or IR
24 2 R30,R31 820
25 2 W5,W6 JUMPER
26 1 W7 HEADER 5X2, pin 4 is cut off as key
27 2 W2,W1 4 amp Pluggable Fuse with sockets
27A 2 W3,W4 1.6 amp Pluggable Fuse with sockets
* 28 5 R20,R23,R33,R9,R45 22K
29 1 U15 COMPARATOR Proprietary
31 9 U21,U22,U23,U24,U25,U26, U27,U28,U29 QS3245SO Quality Semi or Pericom
32 4 JP22,JP21,JP23,JP24 HEADER 31
36 1 U6 74HC14SO
37 1 CR1 DIODE,1N4148
38 1 RP1 2K POT, SINGLE TURN
39 1 BZ1 BUZZER
* 40 4 R10, R5, R21, R22 1.5K
41 1 R35 56K
* 42 6 C8,C33,C34,C35,R42,CR34 .01UF
* 43 1 C9 +0.1UF
44 1 Z1 +1.0UF
45 1 - PCI 32 Bbit Extender Connector (White)
46 1 - PCI Mounting Bracket
47 1 - PCIX32E+ PCB

Note:
1. Cut trace to U1.1 on solder side.
2. Add wire from U1.1 to gold finger pin 34 of A side.
3. Do not install R8, R6, U3, R7, C4, C5,C11,C12.
4. Lift U27 pin 3 and add a 51 ohm between pin 3 and pad.
5. CR20(also named C91) in item 15 is mounted on top of R20 with - polarity toward ground.
6. CR23(also named C90) in item 15 is mounted on top of R23 with + polarity toward ground.
7. CR34 in item 42 is mounted on top of R34.
8. Add a wire between via near U29.10 to negative side of C12 (Gnd).
9. The following parts are on the solder side of the board:

R23,C5,R24,C4,U2,C6,C3,T5,T2,T1,C1,C7,C2,U21,U22,U23,U24,U25,Z21, Z22,Z23,Z24,Z30,Z1,R42,R15,R10,R39,R33,R40,R34,CR34

* parts and procedures are changed after the initial release of the board.


[Back] [Home] [Sales] [Support] [News] [Product] [FAQ]

(C) Copyright 1998, Adex Electronics, Inc. 3 Watson, Irvine, CA 92618, CA 92630, USA. (T) 949-597-1772; (F) 949-597-1729
Email: adex@adexelec.com; Website: http://www.adexelec.com